Troubleshooting Lowered Water Pressure

If you start to experience a lack of water pressure, the problem are frequently inside of your home’s plumbing. Below are a lot of the typical factors to consider whenever troubleshooting a low pressure situation.

Clogged Aerators
If the low water pressure is coming from a certain faucet, your situation could simply be a plugged or blocked aerator. Remove the faucet ends, and check the aerator screen for corrosion, waste, lime buildup or any other blockages that will be constraining water flow. You might find it could be advisable to simply completely clean or remove and replace the aerator altogether.

No Hot Water Pressure
If your low water pressure appears to just be affecting the hot water, there may be a problem with the water heater. Look at the shut off valve near to the hot water heater, being certain it’s properly open. You might need to seek advice from a professional plumbing technician to evaluate the health of your water heater and find out if it’s causing problems with low water pressure.

PRV (Pressure Reduction Valve)
When the decreased pressure issue exists through the entire system, you should check your pressure valve. This may be a bell-shaped component, and is regularly located where the main water line makes its way into the house. If the PRV was improperly adjusted or fails, it can cause a loss in water pressure, or even just no water to the home.

Shutoff Valves
Most households and companies use a main shut-off valve. The location can differ, but most of the time it’ll be located within an independent box right behind the meter or towards the pressure reducing valve. The valve, which allows you to turn off the water flow to your home, can minimize the water flow if not totally open. Even though a bit closed, this shut off valve can decrease flows and reduce the water pressure.

Mineral Deposit Buildup
With regard to older residences, plumbing like galvanized piping can often be found. Through the years, mineral deposit buildup can build within the water pipe and for that reason minimize the interior diameter of the water line, plus the making of the inner components of the pipe rough. Though this corrosion does not result in a health concern, this will likely restrict your flow and pressure. If you ever determine this to be a difficulty, your only option is to upgrade the plumbing in the house with a PEX or copper repipe.

Demands on Your Water System
Whenever the pressure appears to be moderately lower at specific times throughout the day, you’re likely to be experiencing the result of a peaking demand of the water system. There’s typically a couple of peak periods during the day. The initial one is first in the morning when many people are getting ready for school or work. One other is the evening when you are getting back home from work. During this time they are sometimes washing laundry, bathing, or watering their lawns. Over these times, you might notice a pressure decrease, however, you should have a sufficient amount of water providing you do not in addition have one of the many issues referred to within the other troubleshooting tips.